The Quik-Park mounting system on the 120R Loader is designed for easy removal and mounting to and from the tractor without tools.
Just like on the former H120, the parking stand is attached to the mast. To lower it into the park position, simply move the joystick to the raise position once the latches are opened.
To view a video of how the Quik-Park™ system works click here.
NOTE: This video only shows the dismount and mount of the loader without disconnecting the hydraulics. To completely remove the loader, the operator must turn the tractor off, relieve the hydraulics, and then disconnect the hoses from the couplers.
The D120 does not utilize the Quik-Park system as used on the 120R, but rather has two parking stands that are stored within the torque tube for a manual parking process.
Remove the parking stand from the torque tube area and place within the loader foot plate during the parking process (as shown).
Once the loader weight is being supported by the bucket and parking stands, manually remove the pins from the mast assembly and disconnect hydraulics.
After installing the parking stands, removing the parking pins and disconnecting hydraulics, simply back away.
The unique offset head design eliminates cross-pins and cotter pins to retain the pin.
A nut ensures the pins remain in position.
A lubrication groove provides a path for lubrication.
End-of-pin lubrication allows easy access for servicing grease points, which are visible from the side of the loader.
|Front tire||23x8.50-12 6PR R4 CL|
|Rear tire||12.00-16.5 6PR R4 CL|
|Front axle configuration|
|Pump capacity||26.5 L/min|
|Rated pressure||2146 psi|
|Bucket used||General Material 1250|
|Bucket weight||70.2 kg
|Lift capacity at full height||Measured at pivot (U)
754 lbMeasured at 500 mm ahead of pivot (V)
|Lift capacity at 59 in. (1500 mm)||Measured at pivot (W)
743 lbMeasured at 500 mm ahead of pivot (X)
|Boom breakout force||Measured at pivot (Y)
1823 lbMeasured at 500 mm ahead of pivot (Z)
|Bucket rollback force capacity||At maximum height (VV)
1634 lbAt 59-in. (1500-mm) lift height (XX)
1700 lbAt ground-level line (ZZ)
|Dimensions||Maximum lift height (A)
72 in.At full height - bucket level(B)
65.8 in.At full height - bucket dumped (C)
|Overall length (I+F), ft (m)||2786 mm
|Overall height in carry position (J)|
|Digging depth (H)||-88 mm
|Reach||At maximum height (D)
24.7 in.At ground level - bucket level (F)
|Bucket angle||Dump angle, degrees (E)
-40.5 degree (angle)Rollback angle, degrees (G)
29.87 degree (angle)Dump angle, ground
-115.4 degree (angle)
|Cycle times||Loader raise, seconds
3.2 secondsLoader lower, seconds
3.2 secondsBucket dump, seconds
3.1 secondsBucket rollback, seconds